• Custom Brake Hose (0.1m - 5m)

PLEASE BARE WITH US – We have had a problem in that our machine has developed a fault so we can not currently make any brake lines, I will still be selling the hose by itself on its own advert but my unions are not DIY so I do not sell the individual unions.

We are working on recktifying the issue and hope to be up and running again by the end of May, early June

We appologise for any ionconvenience

 

Custom made bespoke hoses for the same sort of price as an “off the shelf” item. The quality of these hoses simply cannot be beaten, stainless steel braid with a clear or coloured wipe clean PVC coating, & stainless steel end fittings all guaranteed for life.

All measurements are inclusive of unions so please provide measurement from the centre eye of a banjo and the furthest end of any other union, exclusive of any bends, i.e. the hoses are measured simpy lying next to a tape measure so if you need a 90 degree bend on a union you do not neeed to measure around the bend of the hose, just to wherer the end of the union will end up.

The Price will automatically adjust as you enter your hose details if extra charges apply

Male or female swivel, with bend if required up to 90 degrees (additional cost for bend, price change made automatically on selection)

10mm Banjo, (copper washers supplied FOC) straight or bent 5 - 90 degrees in 5 degree increments, banjos can also be swept to left or right (No extra charge for bends or sweeps on banjos)

Male Bulkhead connector - without nut (supplied separately)

All the above available in 3/8 x 24 UNF, M10 x 1.0, or M10 x 1.25 threads

Non standard ends include, 8mm & 12mm banjos, female fixed end, female bulkhead connector, male & female swivels with bends & specialised fittings if you have particular requirements you can’t fulfill within our standard ordering procedure above the please email your requirements to [email protected]

Please be aware that due to monitor/computer differences and changes made by our supplier, the colour of hoses may differ slightly. We make hoses to a tolerance of + or - 5mm, it is ALWAYS better to have a hose slightly too long than too short, a short hose can be dangerous, so please make adequate allowance when specifying your hoses. If you require a hose where absolute accuracy is required then please contact us at the time of order & we will do our best to ensure accuracy.

Write a review

Please login or register to review

Custom Brake Hose (0.1m - 5m)

  • £14.50


Tags: custom brake hoses